Felix Engineering Linear Actuator Electric Adjustable Seat Slider Mounts For One Seat 4" Of Travel

Weight was the biggest concern when Felix Engineering developed their 12 volt universal electronic seat slider. Because in offroad racing, every ounce counts. Their seat sliders weigh in at about 8-1/2 pounds compared to their competitors at about 18 pounds. For the average class 9, 10, 11 and 1/2-1600 racers, weight is an important issue.

Other than the weight, other features that it has is 4" of travel and bronze bushings for the assembly to slide back and forth on. A momentary switch is NOT included and must be wired so that one direction of the switch pushes the linear actuator outward (standard polarity) and the other direction of the switch pulls the linear actuator inward (reverse polarity).

Approximate Dimensions
• Mounting tabs are 7-1/8" on center front to back
• Mounting tabs are 14-1/4" on center left to right
• Mounting tabs use 5/16"-24 fine thread bolts
• Side rails are 19" long front to back
• Side rails are 16-7/16" wide on center left to right
• Side rails use 7/16"-14 coarse thread bolts

These sliders are designed to work with side mounting brackets (sold separately) for Bride, Corbeau, Impact, MasterCraft, MOMO Motorsport, MPI Max Papis Innovations, Necksgen Inc., NRG Innovations, OMP, PRP, Pyrotect Safety, RaceQuip Safety, Recaro, Robby Gordon Off-Road, Simpson Race Products, Sparco USA, and Speed carbon fiber, composite, or fiberglass offroad seats. The side mounts need to have a 7-1/8" center to center mounting pattern on the bottom.

For use in offroad or UTV racing where adjustable seats are permitted.