PRP C55 Steel Side Mounting Brackets For Carbon Fiber Or Fiberglass Racing Seats

PRP's side mounting brackets allow you to mount your seat in different heights and at different angles to have a slight tilt to the seat. This allows you to mount your seat in the most ergonomic, efficient, safe, and comfortable position. The bottom flange has oval shaped holes to compensate for different width seats.

These mounts were designed to adapt carbon fiber, composite or fiberglass seat to your UTV side-by-side. They're a slim version of PRP's C51 side mounts to make it easier to install in tight interiors, with access points on the side to tighten down the bolts in hard to reach locations.

Approximate Dimensions:
• Length front to back: 14-3/4"
• Rear highest hole: 4-5/8"
• Front highest slot: 4-5/8"
• Hole vertical spacing: 13/16"

These mounts fit most brands of carbon fiber, composite, and fiberglass off-road racing seats with the industry standard 29cm - 11-7/16" width mounting holes on the sides of the seat such as: