Baja Designs 10-0602 RTL-M Miniature Rear Brake And Tail Light With White Reverse Light

Improve safety during your offroad adventures or races with the Baja Designs LED mini RTL, or Rear Tail Light, offering enhanced visibility at the rear of your vehicle. Visibility is paramount when navigating trails.

Wiring comes out of the left driver side of the light bar. There are four wires with bullet terminals. It has 5 red LED lights. All 5 of the red LEDs function as a brake and taillight. The taillights MUST be powered on for the brake lights to function. It has 3 white LED lights for reverse, cargo or nightlight. If you activate the white lights while the red lights are on, the center red LED turns off and the 3 white LEDs turn on so the white light doesn't get washed out by the red light. The white lights can be switched on independently from the rest of the light bar and be used for reverse lights or it also works great as a nightlight when mounted on the edge of your roof, above the engine, on a rear engine buggy.

Also available with a license plate light part number 10-0601

Wiring (can be used with 64-0127 or 64-0605 harness)

• Black = ground
• Red = running taillights
• Yellow = brake lights
• Blue = white reverse lights

There are two c-channel slots that run the full width of the light bar. This allows you to mount the bar with tabs directly below the bar or behind the bar at any width. The two supplied bolts are 1/4" x 7/8" long. Customers often pick up 1/4" x 2" bolts at a local hardware store and drill two holes straight through the 1-1/2" tube that's on the back edge of their roof on a buggy or truck. The light bar is 1-1/2" thick and this results in a really clean install job.

Specifications

Assuming watts ÷ 13.8 volts = amps