Baja Designs 10-3002 RTL Rear Brake And Tail Light, Solid Amber Dust Lights, White Reverse Light

Improve safety during your offroad adventures or races with the Baja Designs LED RTL, or Rear Tail Light, offering enhanced visibility at the rear of your vehicle. Visibility is paramount when navigating trails, and the amber light's ability to penetrate dust or fog adds an extra layer of safety when racing.

Wiring comes out of the left driver side of the bar. There are four wires with bullet terminals. The center white section can be switched on independently from the rest of the light bar and be used for reverse lights or it also works great as a nightlight when mounted on the edge of your roof, above the engine, on a rear engine buggy.

The running lights MUST be powered on for the brake lights to function. On this particular bar, the amber dust lights are always on with the taillights.

Wiring

• Black = ground
• Red = running lights (red and amber lights)
• Yellow = brake lights
• Blue = white center segment

There are two c-channel slots that run the full width of the light bar. This allows you to mount the bar with tabs directly below the bar or behind the bar at any width. Ideally at 25" on center to prevent damage to the aluminum extrusion. The two supplied bolts are 1/4" x 7/8" long. Customers often pick up 1/4" x 2" bolts at a local hardware store and drill two holes straight through the 1-1/2" tube that's on the back edge of their roof on a buggy or truck. The light bar is 1-1/2" thick and this results in a really clean install job.

Specifications

Assuming watts ÷ 13.8 volts = amps. The RTL can run at 9 to 36 volts