Baja Designs 10-3004 RTL-S Brake And Tail Light, Amber Turn Signals, White Reverse Light

Improve safety during your offroad adventures or races with the Baja Designs LED RTL, or Rear Tail Light, offering enhanced visibility at the rear of your vehicle. Visibility is paramount when navigating trails.

Wiring comes out of BOTH sides of this bar. There are four wires with bullet terminals on the left driver side. There are two wires with bullet terminals on the right passenger side. The center white section can be switched on independently from the rest of the light bar and be used for reverse lights or it also works great as a nightlight when mounted on the edge of your roof, above the engine, on a rear engine buggy.

The taillights MUST be powered on for the brake lights to function. On this particular bar, the amber turn signals are off unless power is applied to that segment. The taillights do not need to be powered on for the turn signals to function. A turn signal flasher relay is NOT included.

There are two c-channel slots that run the full width of the light bar. This allows you to mount the bar with tabs directly below the bar or behind the bar at any width. Ideally at 25" on center to prevent damage to the aluminum extrusion. The two supplied bolts are 1/4" x 7/8" long. Customers often pick up 1/4" x 2" bolts at a local hardware store and drill two holes straight through the 1-1/2" tube that's on the back edge of their roof on a buggy or truck. The light bar is 1-1/2" thick and this results in a really clean install job.

Specifications

Assuming watts ÷ 13.8 volts = amps. The RTL can run at 9 to 36 volts