Ogawa Enterprises Weld On Aluminum Dual 5 Bolt SAE Pattern Flange For Fuel Level Sending Units
![Ogawa Enterprises Weld On Aluminum Dual 5 Bolt SAE Pattern Flange For Fuel Level Sending Units Ogawa Enterprises Weld On Aluminum Dual 5 Bolt SAE Pattern Flange For Fuel Level Sending Units](graphics/en-US/cssui/blank.gif)
![California proposition 65 warning California proposition 65 warning](../mm5/graphics/warning-symbol.png)
Description
This is an aluminum flange that you can use to weld onto a spun aluminum gas tank to hold an Autometer, Centroid Products, Harmon Racing Cells, Jaz Products, VDO or any five bolt SAE pattern fuel level sender.
The reason this flange has 10 holes, is in case you have a lever style sending unit and need to point it in the opposite (180 degrees) direction.
Note: 5 bolt fuel gauge sending units are intentionally asymmetrical. Meaning the spacing between each of the 5 bolt holes isn’t even. Keep spinning the sending unit around and eventually the holes will line up with your fuel sending unit.
The reason this flange has 10 holes, is in case you have a lever style sending unit and need to point it in the opposite (180 degrees) direction.
Note: 5 bolt fuel gauge sending units are intentionally asymmetrical. Meaning the spacing between each of the 5 bolt holes isn’t even. Keep spinning the sending unit around and eventually the holes will line up with your fuel sending unit.
- Inner Diameter: 1-5/8"
- Outer Diameter: 2-5/8"
- Thickness: 1/4"
- Thread Pitch : 10-32