1" or 1-1/8" Shaft 3.0" 3.5" 4.0" Shock 5/8" Tall Internal Spacer For Reducing Overall Length

These aluminum spacers go between the seal head bearing housing and the thick bottom top out washer (part number 050-00-006) to shorten the overall length of your shocks similar to using suspension limiting straps. The spacers are 2" outside diameter.

These spacers come with a 1" hole for the shaft. We can machine them for a 1-1/8" shaft but we charge per spacer to do so.

You will have to drain the nitrogen, take the shock apart, reassemble the shock, and refill it with nitrogen in order to install these. You will need a spanner wrench (usually 1/4" pin) to remove the bottom wiper cap and some soft jaws to hold the shaft while you remove the nut that holds on the valve stacks and piston.

Typical shaft diameters on Fox Shocks:
• 3" Smooth body = 7/8"
• 3" IBP internal bypass coil over = 7/8"
• 3" Non IBP standard coil over = 1"
• 3" External bypass 7/8"
• 3" Short course external bypass 1"
• 3.5" External bypass 1"
• 4" External bypass 1-1/8"

3" shocks with a 7/8" use part number 233-21-103 or 233-21-104 instead.