Wilwood 340-4745 3/8"-24 Brake Bias Balance Bar Replacement For CNC, Jamar, Tilton Racing, Wilwood

Wilwood's pedal assembly balance bar. Direct replacement for many brands of pedal assembly such as CNC, Jamar Performance (not the CA3 floor mount), and Tilton Racing. The kit includes a non coated COM8 uniball. Wilwood machines two 3/8-24 nuts with a 1/2" shoulder on the side of the nuts for the uniball. Any of the uniballs listed below work as a replacement.

Cross Reference Part Numbers:

• CNC 1215 - 3/8" shaft with 5/16"-24 clevises
• CNC 1214 - 7/16" shaft with 5/16"-24 clevises
• Jamar Performance JCA6BB - 7/16" with 3/8" thread on the end
• Tilton Racing 72-250 - 3/8" shaft with 5/16"-24 clevises
• Tilton Racing 72-260 - 7/16" shaft with 5/16"-24 clevises
• Tilton Racing 72-262 - 7/16" shaft with 3/8"-24 clevises
• Wilwood 340-1757 - 3/8" shaft with 5/16"-24 clevises (with weld sleeve)

Specifications:

• Uses standard 5/16"-24 brake master cylinder push rods
• Includes a COM8 style uniball 1" OD x 1/2" ID
• Shaft is 3/8"-24 thread x 4-7/8" wide

On the right hand side clevis you'll notice a tiny slotted screw with a jam nut. The tip of that screw has a spring loaded ball that clicks into a groove cut into one side of the 3/8" shaft. Every 360 degree revolution, the ball snaps into that groove. If you're using a dash mount bias adjuster knob that already has a detent click, then you can simply remove the slotted screw from that clevis.