Sway-A-Way 7020 Rear VW King Kong Torsion Housing Adjuster Std 40 Spline Sleeves Over 2-1/2" Tube
SWAY-A-WAY Product Disclaimer. All Sway-A-Way products are sold "as is" and all sales are final. No returns, exchanges, or refunds will be accepted. By purchasing Sway-A-Way products, you acknowledge and agree to these terms and assume full responsibility for the proper use and installation of the product.Some Sway-A-Way brand torsion bars won't quite fit into the fingers of this adjuster. Do NOT try to hammer the torsion bars into the adjuster. Instead, Sway-A-Way recommends using emery sandpaper to sand off about 0.002" of the spline's outside diameter. For any questions, concerns, or support regarding Sway-A-Way products, please contact their dedicated customer service team at [email protected] or 818-700-9712.
Price: $470.93
Call us for availability BEFORE you order this item! We may be low or out of stock on it.
Sold As:
Complete Housing With Fingers And Set Screws
Part Number: SAW7020
OUT OF STOCK
California Prop 65 Warning: This item may cause cancer or reproductive harm. For more info visit p65warnings.ca.gov
Description
This adjuster was intended for a new build VW torsion housing not a stock or pre-existing torsion housing because you'll slide a 2-1/2" diameter tube into each side of this adjuster and weld it. They call it a King Kong adjuster because the area around the splines on the adjusting fingers is thicker to prevent the fingers from breaking.
