Sway-A-Way 7000 Rear VW Torsion Housing Adjuster Standard 40 Spline Butts Up To 2-1/4" Tubing
SWAY-A-WAY Product Disclaimer. All Sway-A-Way products are sold "as is" and all sales are final. No returns, exchanges, or refunds will be accepted. By purchasing Sway-A-Way products, you acknowledge and agree to these terms and assume full responsibility for the proper use and installation of the product.Some Sway-A-Way brand torsion bars won't quite fit into the fingers of this adjuster. Do NOT try to hammer the torsion bars into the adjuster. Instead, Sway-A-Way recommends using emery sandpaper to sand off about 0.002" of the spline's outside diameter. For any questions, concerns, or support regarding Sway-A-Way products, please contact their dedicated customer service team at [email protected] or 818-700-9712.
Estimate Shipping
Price: $442.12
Call us for availability BEFORE you order this item! We may be low or out of stock on it.
Sold As:
Complete Housing With Fingers And Set Screws
Part Number: SAW7000
California Prop 65 Warning: This item may cause cancer or reproductive harm. For more info visit p65warnings.ca.gov
Description
This adjuster was intended for a stock VW torsion housing. You'll have to cut roughly a 3-7/8" wide section out of the pre-existing torsion housing, slide this into place, and butt weld it on either side.
