Sway-A-Way 5409 IRS Or Swing Axle Weld On Collar For Making Spring Plates Using 21-3/4" Bars

SWAY-A-WAY Product Disclaimer. All Sway-A-Way products are sold "as is" and all sales are final. No returns, exchanges, or refunds will be accepted. By purchasing Sway-A-Way products, you acknowledge and agree to these terms and assume full responsibility for the proper use and installation of the product.

Some Sway-A-Way brand torsion bars won't quite fit into these collars. Do NOT try to hammer the torsion bars into these collars. Instead, Sway-A-Way recommends using emery sandpaper to sand off about 0.002" of the spline's outside diameter. For any questions, concerns, or support regarding Sway-A-Way products, please contact their dedicated customer service team at support@x-sway.com or 818-700-9712.

Sway-A-Way 5409 IRS Or Swing Axle Weld On Collar For Making Spring Plates Using 21-3/4" Bars
Price: $75.05
Call or email for availability
Sold As: 1 Spring Plate Collar

Part Number: SAW5409

MFG Number: 5409


Order this item to pickup at our Corona, CA store. You'll pay when you get here. You can pay by credit card, cash or PayPal and we'll contact you when this order is ready for pickup.


California proposition 65 warningCalifornia Prop 65 Warning: This item may cause cancer or reproductive harm. For more info visit p65warnings.ca.gov

Description

If you have a stock width VW rear torsion housing, these collars allow you to make your own spring plates setup for 21-3/4" long torsion bars.

If you widen the torsion housing 3" (1-1/2" per side) you would use this collar and 24-11/16" torsion bars.

If you widen the torsion housing 9-5/8" (4-13/16" per side) you would use this collar and 26-9/16" torsion bars.

Related Parts

Scroll Top