PME Race Porsche 934 Rear Midboard Micro Stub Brake Kit AT6R 6 Piston Calipers 11-7/8" Vented Rotors
Price: $4,999.99
Call us for availability BEFORE you order this item! We may be low or out of stock on it.
Sold As:
1 Complete Disc Brake Kit
Part Number: PMERH5205MBMS934AT6V
California Prop 65 Warning: This item may cause cancer or reproductive harm. For more info visit p65warnings.ca.gov
Description
Features:
Heavy Duty Race Quality 7075 Aerospace Grade Aluminum
Hard Anodized - Hubs Will Have A Tan To Grey Appearance
Rotor Diameter: 12"
Rotor Thickness: 3/4"
Wilwood Racing AT6R 6 Piston Calipers
33 Spline 934 Mid-Board Micro Stub Axles (Stubs available with 1/2" thread or 7/16" thread)
3.90" Diameter Ten Bolt Mid-Board Micro Stub Bearing Housing
14mm 1.5 Thread Wheel Studs
This hub kit by default comes with micro stub axles threaded for 1/2" CV joint bolts. If your CV's have not been drilled out for 1/2" bolts and they still use 12mm bolts then you can also order this kit with stubs threaded for 7/16" thread.
This kit is for a MIDBOARD micro stub trailing arm plate. See below picture for reference.
What's Included:
Two 5 Lug VW Pattern (5 on 205mm) Hubs
Two Calipers With Pads
Two Hub Caps
Two Micro Stub Hub Bearing Assemblies
Two 33 Spline Stub Axles
Two Axle Nuts
Specs:
Uses standard DOT 3, DOT 4 or DOT 5.1 brake fluid
1/8" NPT pipe thread inlet (You'll need adapter fittings listed below)
Rotors have 14mm-1.5 thread studs pressed into them (You'll need to purchase lug nuts)
This hub kit by default comes with micro stub axles threaded for 1/2" CV joint bolts. If your CV's have not been drilled out for 1/2" bolts and they still use 12mm bolts then you can also order this kit with stubs threaded for 7/16" thread.
This kit is for a MIDBOARD micro stub trailing arm plate. See below picture for reference.
What's Included:
Two 5 Lug VW Pattern (5 on 205mm) Hubs
Two Calipers With Pads
Two Hub Caps
Two Micro Stub Hub Bearing Assemblies
Two 33 Spline Stub Axles
Two Axle Nuts
Specs:
Uses standard DOT 3, DOT 4 or DOT 5.1 brake fluid
1/8" NPT pipe thread inlet (You'll need adapter fittings listed below)
Rotors have 14mm-1.5 thread studs pressed into them (You'll need to purchase lug nuts)
