Fox 2.0" / 2.5" Performance Shock Bottom Eyelet 7/8" SHALLOW Thread 4" Top Edge To Center Uses COM12
Estimate Shipping
Price: $46.44
In Stock
Sold As:
1 End Loop
Part Number: FOX21437040
MFG Number:
214-37-040
California Prop 65 Warning: This item may cause cancer or reproductive harm. For more info visit p65warnings.ca.gov
Description
Does not use the traditional half moon clips. Uses a single thick wire clip style spring perch.
This end loop is normally found on a Performance Series shock but beware that Fox uses two different thread lengths on their Performance Series shocks.
It's important to realize that anything 2.5" or greater, regardless of shaft diameter, all have 7/8" thread on the bottom. So for example, if you have a 7/8" shaft, 1" shaft, 1-1/8" shaft or 1-5/8" shaft, they all have 7/8" thread on the bottom. The problem is the length of the threads.
A common question that we get is, "can any Fox 7/8" threaded eyelet be used on any Fox shock?". It depends on the shaft and how deep the threads are on the eyelet. A Fox 2.0" shock with a 7/8" shaft and some Performance series 2.5" shocks have shorter threads on the shaft and the eyelet is threaded shallower than a Factory Series 2.5" or larger shock. See the example of the thread length on this shaft photo.
This eyelet has a 7/8"-14 thread pitch. It has "SHALLOW" threads. It can be used on a Fox bypass, smoothie, or coil over.
It's important to realize that anything 2.5" or greater, regardless of shaft diameter, all have 7/8" thread on the bottom. So for example, if you have a 7/8" shaft, 1" shaft, 1-1/8" shaft or 1-5/8" shaft, they all have 7/8" thread on the bottom. The problem is the length of the threads.
A common question that we get is, "can any Fox 7/8" threaded eyelet be used on any Fox shock?". It depends on the shaft and how deep the threads are on the eyelet. A Fox 2.0" shock with a 7/8" shaft and some Performance series 2.5" shocks have shorter threads on the shaft and the eyelet is threaded shallower than a Factory Series 2.5" or larger shock. See the example of the thread length on this shaft photo.
This eyelet has a 7/8"-14 thread pitch. It has "SHALLOW" threads. It can be used on a Fox bypass, smoothie, or coil over.
