Foddrill Oversized 1st Gen Replacement 1-3/4" Dia Beam Spindle King Pin For Combo Link Or King Kong

Foddrill's oversized replacement 1-3/4" diameter king pin. This is the first generation style that uses a snap ring and washer on both ends of the king pin. Will fit their combo link or king kong spindles that use the B-2824 Timken bearings. The bushings, bearings, washers, snap rings, link pin shims, and zerk fittings are all sold separately. The upper and lower holes are both 1-1/8" allowing you to run either 5/8" (18mm) link pins or 7/8" link pins.

Oversized king pins were created for old style Foddrill spindles where the king pin's bearing carrier, 3 bolt backing plate, and spindle snout were all three separate pieces. Foddrill used to weld those 3 pieces together and the heat would sometimes cause the king pin's bearing carrier to warp slightly into an oval shape. Foddrill later solved that problem by making a full billet, one piece chromoly, bearing carrier that is all one piece with the 3 bolt backing plate and spindle snout.

Be sure to measure the diameter of your king pin. With Foddrill's spindles you can buy them with a variety of combinations for example:

• 1-1/2" king pin with combo link snouts
• 1-1/2" king pin with king kong snouts
• 1-3/4" king pin with combo link snouts
• 1-3/4" king pin with king kong snouts