Autometer 5671 Elite Color Changing LED 2-1/16" Electric Stepper Motor 0-100 PSI Fuel Pressure Gauge

Are you going to a night race in the desert? Similar to the Phantom II, Sport-Comp II and Ultra-Lite II the new Elite series gauges have bright LED lights that illuminate through the numbers, providing clear visibility during nighttime use. You can select seven different colors (red, yellow, green, cyan, blue, violet and white) to match your vehicle's scheme, visibility conditions or low and high warning.

Dimmable Or Off
• This gauge allows the dial lighting to operate in full on, dimmable or no backlight color.

Backlight Color
• You can select seven different colors (red, yellow, green, cyan, blue, violet and white) or you can select no color. With the no color option, if the gauge reaches a certain peak pressure, you can set it to light up to get your attention. If the gauge reaches a pressure above or below your peak settings, the gauge will light up and flash the color of your choice.

Full Dial Warning
• When a warning point is reached, the entire dial illuminates in the programmed warning color. This feature is available for both a low pressure and high pressure warning set point. In addition, the warning color will flash when an over warn point is reached.

Recall
• You can recall the highest pressure reading since the memory was last cleared.

Data Logger Output
• Equipped to output the sensor signal to an external data logger system (not included). This feature allows you to use the same sensor for both the gauge and the data logger.

Pro Control
• Pro Control can be used to switch on a relay to activate an ignition kill switch, cooling fans, dash lights, alarms, etc. There are three segments on the gauge dial, the segment below the low set point, between the set points, and above the high set point. Pro Control outputs can not exceed 2 amps at 12 volts. That's why the output triggers a relay and then the relay activates your accessory.