Sweet Manufacturing GM 1000 PSI Aluminum Body T/C Power Steering Pump #6 Outlet #10 Return

Average Flow: 3.5 GPM

When you install a pulley (using a GM pulley installer), you'll notice that the pulley's hub is wider than the length of the shaft sticking out of this TC pump. Most of the pulleys that we sell have a 0.960" hub width. The shaft on this pump is roughly 0.890" long. The pulley's shaft should be roughly 0.070" down. See photo below.

The pump's shaft should sit slightly below the edge of the pulley. Do not make the shaft flush with the face of the pulley. When you tighten down the nut on the GM pulley installer, if you accidentally go too far, on the other end of the pump's shaft is a tiny clip that could break off of the shaft.


Important Note: NEVER use a hydraulic press to install your pulley. Using a press will crush the back side of your power steering pump. Use a GM pulley installer. The GM installer threads into the front of the pump and pulls the pump into the pulley.