Nylon 11 Inch Long Black Four Layer Suspension Limiting Strap With 4130 Heat Treated Chromoly Ends

Note: We are phasing out our logo on our limit straps. We will do our best to make sure, if you order two of the same length straps, that they match. If you order two different length straps for example two 20's and two 24's you might end up receiving two with a logo and two without until we eventually run out of all the straps that have a logo.
Nylon 11 Inch Long Black Four Layer Suspension Limiting Strap With 4130 Heat Treated Chromoly Ends
Rough Shipping Estimate
Estimate Shipping
Price: $32.99
In Stock
Sold As: 1 Suspension Limiting Strap

Part Number: KTKLS311

MFG Number: LS311


Order this item to pickup at our Corona, CA store. You'll pay when you get here. You can pay by credit card, cash or PayPal and we'll contact you when this order is ready for pickup.


California proposition 65 warningCalifornia Prop 65 Warning: This item may cause cancer or reproductive harm. For more info visit p65warnings.ca.gov

Description

11" Limiting strap length is measured from center of bolt hole to center of bolt hole. The bolt holes are 9/16" in diameter. The strap's webbing material is rated between 14,000 to 15,000 pounds. The 4130 chromoly ends are rated to 15,000 pounds.

Limiting straps are ideal for any off road application since they are vital in preventing damage to your suspension and drive train components. Without limiting straps, your shocks act as stops at maximum droop which can cause damage from your vehicle's unsprung weight. Limiting straps also prevent damage to your CV's by limiting the amount of maximum angle on your axles. The limit straps we carry are four-ply so only 1" of stretch is allowed for every 12" of strap. Chromoly Chrome-Moly Chrome Moly

How to mount the bottom of the limiting straps

If you're going to use an adjustable clevis then you'll need to compensate for the extra length of the clevis. See clevis diagram. An adjustable clevis allows you to fine tune your suspension and it also allows you to shorten the distance as the strap stretches over time.

You want to make sure that you double shear the bottom of the limiting strap mount for extra strength. Ideally, you would use a grade 9 bolt such as f911. The tab on the limiting strap and the tab that you weld to the chassis should always be lined up in the direction the limiting strap is going to pull. You never want to mount the tab "flat" to a surface because it will bend and eventually fail.
How to measure suspension limiting straps with an adjustable clevis

Related Parts

Scroll Top