Kartek Offroad 1.5:1 Ratio Rack And Pinion With 11" Bump Steer Brkt For Desert Dynamics Buggy Works
California Prop 65 Warning: This item may cause cancer or reproductive harm. For more info visit p65warnings.ca.gov
Description
Our billet 6061 aluminum fully polished center load steering rack and pinion for Buggy Works, Desert Dynamics, Desert Rat Buggies or other A-arm front steer sand rails. On a Buggy Works, Desert Rat Buggies, or small Desert Dynamics sand rail the rack and pinion will use RSMX10-8T heim joints with a 1/2" hole. On the spindles you'll use JMXL12T heims with 1/2" misalignment to get enough angle when the arm fully drops down.
-
Specs:
- American Made
- Fully Rebuildable
- 3/4" 48 Spline Pinion
- Depth: 2-1/4" (not including pinion or face plate)
- Width: 12-9/16"
- Travel: 4"
- Standard 6" x 1" mounting pattern
- Uses 3/8" bolts and nuts
- Tie Rod Mounting Holes: 1/2"-13 coarse thread
- Tie Rod Mounting Hole Width: 11" on center
- Uses KMX128 or RSMX10-8T heim joints
- Tie rods must be in FRONT of spindles
