Weld On Backing Plate For 2" or 2-1/2" Hollow Bolt-On Spindle Snout 8 Bolt 3-3/4" Ptrn 2-7/8" Center
California Prop 65 Warning: This item may cause cancer or reproductive harm. For more info visit p65warnings.ca.gov
Description
This bolt on snout backing plate allows either a 2" or 2.5" bolt-on snout to be used when making custom uprights. The design allows for an easy alignment and comes with the holes already tapped.
If you're using Jamar, Kartek Offroad, or PME eight bolt spindle snouts to make your own upright, you'll also need to use our 3/8" x 1" bolts listed below.
If you're using Jamar, Kartek Offroad, or PME eight bolt spindle snouts to make your own upright, you'll also need to use our 3/8" x 1" bolts listed below.
-
Specs:
- Bolt Pattern: 8 on 3-3/4"
- 3/8"-24 Fine thread
- 1/2" Thick
- 4-7/8" Wide
- 4-7/8" Tall
- 2-7/8" Diameter center hole
